Connecting The Monitor/Outdoor Station; Connecting A Strike Plate Or Electric Lock; Connecting A Gate Motor; Connecting The Electrical Supply - Extel IRON 2 Guide D'installation Et D'utilisation

1. Firmly connect the devices according to the wiring diagrams. (see figs. 6-7-8-9)
2. Only 2 wires are required for all functions:
Bell sound, image, sound, automatic opener control and strike plate or electric lock control.
Distance between the last panel
and the last monitor
From 1 to 100 metres
WARNING: Do not, under any circumstances, double up small sections of wire to make 1.5mm
a. Connecting the monitor/outdoor station
• Terminals "C+" "C-" of the monitor to terminals "C+" "C-" of the outdoor station.
To avoid any video disturbance, you are advised to reduce the distance between the most distant monitor and the
outdoor station, if possible (see star wiring fig.9)
b. Connecting a strike plate or electric lock (
Connect directly to the terminals
Note that this function is only available when the screen is turned on. The picture disappears briefly
when the control is activated.
Important: The strike plate or electric lock that you are about to install must have a mechanical memory and be
energy efficient, like all EXTEL products.
c. Connecting a gate motor
Connect directly to the terminals
no current, to be connected to the "push button" control of your automatic opener.
Note that this function is only available when the screen is turned on.
d. Connecting the electrical supply
Connect it directly to the P+ and P- terminals at the back of the monitor. (Take care to observe proper polarity)
- A single power unit is sufficient when installing with multiple monitors.
- The power supply must be installed on the monitor closest to the first outdoor station.
e. Monitor/outdoor station pairing settings for a basic kit (Fig. 6)
Your videophone comes already paired for basic configuration. You can check the pairing or change it, as applicable,
by doing the following:
For the monitor:
- Press the key, then select ID using the cursor,
You can set the address of your monitor by pressing the
, exit the menu with
On the back of the monitor, the On-Off micro-switch (fig 2.10) must be in the ON position
- Outdoor station:
the outdoor station is set using the micro-switches (Fig.4.h)
Type of cable to be used
Two 1.5 mm² wires
of the outdoor station (no need to observe polarity).
(fig. 6)
of the outdoor station. The outdoor station delivers a "dry" contact with
(fig. 6)
HOUSE 0 = Family 1
HOUSE 1 = Family 2
ROOM 1 = Main phone
ROOM 2 = Secondary phone
the configuration for a basic kit must be HOUSE 0 ROOM 1
.
CFI EXTEL IRON 2 - V1 - 01/2013
fig. 6)
, validate by pressing the key
and keys, validate your settings by pressing
2
.
GB4