Safety Practices To Avoid Personal Injury - Thermador PROFESSIONAL PRO HARMONY PRG304GH Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour PROFESSIONAL PRO HARMONY PRG304GH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING!
To avoid possible burn or fire hazard, a back guard
designed specifically for this range must be installed
whenever the range is used.
CAUTION!
The high shelf can get hot! DO NOT place the following
items on top of the high shelf:
plastics or containers that can melt
flammable items
a total load over 30 lbs. (13.6 kg)
WARNING!
ALWAYS DISCONNECT THE ELECTRICAL PLUG
FROM THE WALL RECEPTACLE BEFORE
SERVICING THIS UNIT.
CAUTION!
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE CONNECTED TO A PROPERLY GROUNDED AND
POLARIZED ELECTRICAL POWER SUPPLY.
WARNING!
IN CASE OF AN ELECTRICAL FAILURE
If for any reason a gas control knob is turned ON and
there is no electrical power to operate the electronic
igniters on the range's cooktop STAR
OFF the gas control knob and wait 5 minutes for the
gas to dissipate before lighting the STAR burner
manually.
To light the STAR burners manually, carefully hold a
lighted match to the STAR burner ports and turn the gas
.
control knob to HI
During a power failure, you can use the standard
cooktop STAR burners, but each must be lit with a
match.
DO NOT attempt to light the two left XLO
burners manually. These STAR burners are equipped
®
with the ExtraLow
feature and cannot be lit manually.
English 2
30" Gas Model:
120 V, 60 Hz., 10 Amp dedicated electrical circuit required.
36" Gas Models:
120 V, 60 Hz., 10 Amp dedicated electrical circuit required.
36" gas range with electric griddle or grill - 20 Amp circuit
required.
48" Gas Models with electric griddle or grill:
120 V, 60 Hz., 20 Amp dedicated electrical circuit required.
It is recommended that a dedicated circuit servicing this
appliance be provided. See Installation Instructions for
electrical requirements and grounding instructions.
The use of gas cooking appliances results in the production
of heat and moisture.
It is the personal responsibility and obligation of you, the
user, to have this appliance connected to the electrical
power supply by a qualified electrician, in accordance with
the National Electrical Code and/or applicable local codes
and ordinances.
TESTED IN ACCORDANCE WITH:
®
burners, turn
Check your local building codes for the proper method of
installation. In the absence of local codes, this unit should
be installed in accordance with the National Fuel Gas Code
No. Z223.1 current issue and the National Electrical Code
ANSI/NFPA No. 70 current issue or the Can - B149
Installation Codes for Gas Burning Appliances and C22.1
Canadian Electrical Code Part 1.
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
®
STAR

Safety Practices to Avoid Personal Injury

When properly cared for, your new THERMADOR
PROFESSIONAL
reliable appliance. However, use extreme care when using
this restaurant caliber range as this type of appliance
provides intense heat. When using kitchen appliances,
basic safety precautions must be followed, including the
following:
UL 858, The Standard for the Safety of Household
Electric Ranges
ANSI Z21.1, The American National Standard for
Household Cooking Gas Appliances
CAN 1-1.1-M81, Domestic Gas Ranges
CSA C22.2 No. 61, Household Cooking Ranges
TM
range has been designed to be a safe,

Publicité

Table des Matières
loading

Table des Matières