Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintaining Your Product
Follow the instructions in this chapter to check and clean the print head nozzles, check ink
levels, and replace ink cartridges. If you need to align the print head, see the online
User's Guide.
Caution: To keep your product looking new, don't place anything on top of the cover or
use it as a writing surface. If you need to clean the cover, use only a soft, non-abrasive
microfiber-type cloth.
Checking the Print Head Nozzles
If your printouts are faint or have gaps in them, some of the nozzles in the print head may
be clogged or ink may be running low in one or more of the ink cartridges. Follow the
steps below to check the print head nozzles.
1.
Load a few sheets of plain paper in cassette 1.
2.
Press
if necessary and select
3.
Select
Maintenance
4.
Press x.
5.
Check the nozzle check pattern that prints to see if there are gaps in the lines.
Nozzles are clean
6.
If there are no gaps, the print head is clean. Select
If there are gaps or the pattern is faint, select
the print head (see page 26).
.
Setup
, then
.
Nozzle Check
Nozzles need cleaning
Finish Nozzle Check
. Then press
Head Cleaning
Maintaining Your Product
.
to clean
OK
25
Publicité
Table des Matières
