Celexon DELUXX SCREEN ELECTRIC PROFESSIONAL Manuel D'installation page 15

ENGLISH – Rolling screen installation and operation manual
A – Left Motor
PROGRAMMING END STOPS MOTOR SOMFY RTS 230V 50Hz/120V 60Hz (procedures already carried out in factory, SHOULD NOT be performed by unauthorised personnel)
Move the
screen surface
to down limit
switch.
1.
Move the
screen surface
to up limit
switch.
Made by celexon Germany GmbH & Co. KG - Gutenbergstraße 2 - 48282 Emsdetten, Germany / www.deluxx.com
DELUXX® is a brand of celexon Germany GmbH & Co. KG
Specifications are subject to change without prior notice.E&OE
Doc: Classic Winch Professional Installation Manual rev2 | 05.07.2017
Please verify that you are working with the latest revision of this document before specifying your screen.
10 END STOP NICE MOTOR ADJUSTMENT
1 Press both
and
same time until you will see
a brief up and down motion
of screen surface.
Press both
and
same time until you will see
a brief up and down motion
of screen surface.
Back fall - C
Frontal fall - D
Down limit switch
2
Move the screen with
at the
to reach the desired
down limit position.
Up limit swicht
2
Move the screen with
at the
to reach the desired up
B – Right Motor (standard)
3
4
buttons
Press button until you
will see a brief up and down
and
motion of screen surface to
memorize the new position
3
4
buttons
Press button until you
will see a brief up and down
and
motion of screen surface to
memorize the new position
limit position.
Page 15