Panasonic EYFGA1N Instructions D'utilisation page 7

V.
OPERATION
Before Using the Remote
Control (Available as an
optional accessory)
Insert the battery
1. Pull out the battery holder.
1 Push in on the fas-
tener as indicated by
the arrow.
2 Pull out the holder.
. Insert the battery and
push the holder
back in.
NOTE:
• If the tool does not respond to the wire-
less remote control even when the remote
control is operated close to the tool, the
battery (CR05) is dead. Replace it with
a new battery.
• The included battery is provided for sample
use and may not last as long as commer-
cially available batteries.
Wireless remote control range
The remote control should be operated within
approximately 50 cm and approximately 60°
vertically and horizontally of the perpendicular
relative to the infrared receiver on the tool.
• Under the following circumstances, you may
not be able to operate the tool, even within
this range.
• If there is an object between the remote
control's transmitter and the tool's receiver.
• When used outdoors or in other environ-
ments where the remote control receiver is
exposed to a strong light source, or when
the remote control transmitter or receiver is
dirty, the tool fails to respond, even when the
remote control is used within the operating
range.
[Main Body]
Switch and Forward/Reverse
Lever Operation
Forward
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit comes
to a complete stop.
- 7 -
Vertically
Reverse
Switch lock