Attaching Or Removing Bat­ Tery Pack - Panasonic EYFGA1N Instructions D'utilisation

Symbol
V
n
0
... min
-1
reciprocations per minutes
Electrical capacity of battery
Ah
injury, user must read and
Do not incinerate or heat
battery pack. Do not charge
or use under conditions of
high temperature. Do not ex-
pose to high temperatures.
Do not expose to rain or
IV
ASSEMBLY
.
Attaching or Removing Bit
NOTE:
• When attaching or removing a bit, discon-
nect battery pack from tool or place the
switch in the center position (switch lock).
1. Hold the collar of quick connect chuck and
pull it out from the tool.
. Insert the bit into the chuck. Release the
collar.
3. The collar will return to its original position
when it is released.
4. Pull the bit to make sure it does not come out.
5. To remove the bit, pull out the collar in the
same way.
Meaning
Volts
Direct current
No load speed
Revolutions or
pack
To reduce the risk of
understand instruction
manual.
Do not disassemble or
modify.
water.
CAUTION:
• If the collar does not return to its origi-
nal position or the bit comes out when
pulled on, the bit has not been properly
attached. Make sure the bit is properly
attached before use.
9 mm – 13 mm
(3/64" – 33/64")
Attaching or Removing Bat­
tery Pack
1. To connect the battery pack:
Align the highlighted marker points and
attach battery pack.
• Slide the battery pack until it locks into
position.
Alignment
marks
2. To remove the battery pack:
Push down the button and slide the battery
pack forward.
Button
- 6 -
6.35 mm
(1/4")