Installation - AEG HE634200XB Notice D'utilisation

30 www.aeg.com
and number comes
on.
comes on
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Problem Possible
Incorrect cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
There is an error in the
appliance.
There is an error in the
appliance because a
cookware boils dry. The
overheating protection
for the cooking zones
and the Automatic
Switch Off operate.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
• Before the installation of the appli-
ance, record all the information that is
on the rating plate. The rating plate is
on the bottom of the appliance cas-
ing.
Remedy
Use the correct cook-
ware.
Move cookware to a
smaller cooking zone.
Disconnect the appli-
ance from the electrical
supply for some time.
Disconnect the fuse from
the electrical system of
the house. Connect it
again. If comes on
again, speak to the serv-
ice centre.
Deactivate the appli-
ance. Remove the hot
cookware. After approxi-
mately 30 seconds, acti-
vate the cooking zone
again. If the cookware
was the problem, the er-
ror message goes out of
the display, but the re-
sidual heat indicator can
stay. Let the cookware
become sufficiently cool
and refer to "Cookware
for the induction cooking
zone" to see if your
cookware is compatible
with the appliance.