Publicité
®
R&S
RT-ZZ80
2
1
Special accessories for signal socket
The signal socket of the R&S RT-ZZ80 has a special design to ensure opti-
mal performance. The signal socket is not compatible to standard accesso-
ries based on 0.64 mm (25 mil) square pins or 0.8 mm (35 mil) round pins.
Use only special accessories for R&S RT-ZZ80 provided by Rohde &
Schwarz.
1.4.2
SMA Connector and SMA to BNC Adapter
The R&S RT-ZZ80 has an SMA male connector for connection to the instrument.
To connect the probe to an Rohde & Schwarz oscilloscope, for example, to an
R&S RTO, you need the SMA to BNC adapter that is delivered with the probe.
Screw the SMA connector on the SMA to BNC adapter as shown below.
► Use a torque wrench to tighten the SMA connector.
User Manual 1409.7689.02 ─ 02
Description of the Probe
(1) Signal socket
(2) Ground socket
The accessories supplied for the probe head
sockets are listed in
ries
Supplied",
on page 11.
The ground socket is compatible with 0.64 mm
(25 mil) square pins and 0.6 mm to 0.8 mm
(24 mil to 35 mil) round pins.
Product Description
chapter 1.5.1, "Accesso-
9
Publicité
