Neopost IM-22 Guide De L'utilisateur page 12

OPERATION
Feed modes can be changed on feed settings page 1 by pressing on the desired feed mode.
The selected feed mode will be highlighted with a tick mark as shown below:
Basic Selected
Use the up and down buttons on the left side of the screen to navigate between the three feed
settings pages.
To adjust the value for On Delay, press the number next to "Delay (msec)" on feed settings
page 2.
To adjust the value for On Demand, press the number next to "Demand (mm)" on feed settings
page 2.
The IM-22 and IM-27 letter openers are equipped with an idle shutoff which will stop the
machine after a set time if no envelopes are being processed. To adjust the value for the idle
shutoff, press the number next to "idle shutoff (sec)" on feed settings page 3.
The milling cutter can be turned off so the machine can be used without opening envelopes as
they are processed through the machine. To turn off the milling cutter, press the switch next to
"Milling Cutter" on feed settings page 3.
On Demand Selected
After pressing the On Delay value, a keypad will appear
allowing for the number to be changed. The number
must be equal to or between 1 and 10,000 milliseconds.
After pressing the On Demand value, a keypad will
appear allowing for the number to be changed. The
number must be equal to or between 30 and 400
millimeters.
After pressing the idle shutoff value, a keypad will
appear allowing for the number to be changed. The
number must be equal to or between 20 and 600
seconds.
The switch indicates the current status of the milling
cutter. To turn the milling cutter back on, touch the
switch again until it displays "ON".
On Delay Selected
PAGE 10