Husqvarna LC 140SP Manuel D'utilisation page 12

To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 33)
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Stay behind the product.
3. Hold the engine brake handle against the handlebar.
(Fig. 34)
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
WARNING:
rope around your hand.
To use the drive on the wheels
• Push the drive bail in the direction of the handlebar.
(Fig. 35)
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance
Do a general inspection
Examine the oil level
Replace the oil (the first time after 5 h of use, then after each 50 h of
1
use)
1
If the product is operated with heavy load or in high ambient temperatures, replace the engine oil each 25
hours.
12
Do not set the cutting height
Do not twist the starter
Maintenance
Before you do
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
To stop the product
• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass and
dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
inner surface of the cutting cover on page 13 .
Maintenance schedule
CAUTION:
is up and not against the ground when you
tilt the product. Risk of engine damage.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 9 .
Daily
X
X
To clean the
Make sure that the air filter
Monthly Each season
X
1562 - 002 - 29.10.2021