Publicité
Les langues disponibles
Les langues disponibles
8.MAINTENANCE
AFTER 25 HOURS OF USE
AIR CLEANER
Check and clean the filter element in warm, soapy water as required. Dry completely
before installing. If the element is broken or installing. If the element is broken or
shrunk, replace with a new one.
Important
A clogged air filter may increase fuel consumption while cutting down the engine
power
And operate the brush cutter without the air filter of with a deformed filter element will
quickly ruin the engine.
FUEL FILTER
Take the filter out of the fueling port using a small wire hook.Disconnect the filter
assembly from the fuel pipe and unhook the retainer to disassemble it.Clean the
components with gasoline
IMPORTANT
A clogged fuel filter may cause poor acceleration of the engine.
SPARK PLUG
Remove and inspect the spark plug and clean the electrodes as necessary with
brush.
The spark gap should be adjusted to 0.6~0.7mm(F15).
When replacing spark plug,use only products which have been designated by
INTAKE AIR COOLING VENT
Check the intake air cooling vent and the area around the cylinder cooling fins
IMPORTANT
Note that failing to do so could cause the muffler to become overheated,and that this in turn could cause the brushcutter to
catch on fire.
GEAR CASE
Supply multi-purpose grease at every 25 hours of use.
AFTER 100 HOURS OF USE
MUFFLER
1.Remove the muffler, insert a screwdriver into the vent, and wipe away any carbon buildup. Wipe away any carbon
buildup on the muffler exhaust vent
73
Publicité
