Publicité
Les langues disponibles
Les langues disponibles
machine must be used during operation.
Never operate the engine with faulty exhaust muffler.
Shut off the engine during transport.
During transport over long distances the tool protection
included with the equipment must always be used.
Make sure the unit is secure during transport by car.
To prevent leakage of fuel during transport of
multi-function tool, make sure the fuel tank is completely
empty.
When unloading the Multi Function Power Head from the
truck, never drop the engine to the ground or this may
severely damage the fuel tank.
Except in case of emergency, never drop or cast the Multi
Function Power Head to the ground or this may severely
damage the Multi Function Power Head.
Remember to lift the entire equipment from the ground
when moving the equipment. Dragging the fuel tank is
highly dangerous and will cause damage
and leakage of fuel, possibly causing fire.
Always install the approved cutting tool guard onto the
equipment before starting the engine.
Otherwise contact with the cutting tool may cause serious
injury.
All protective installations and guards supplied with the
machine must be used during operation.
Never operate the engine with faulty exhaust muffler.
Shut off the engine during transport.
When transporting the equipment, always attach the
cover to the metal blade.
Ensure safe position of the equipment during car
transportation to avoid fuel leakage.
Refuelling
Shut off the engine during refuelling, keep away from
open flames and do not smoke.
Avoid skin contact with mineral oil products. Do not inhale
fuel vapor. Always wear protective gloves during
refuelling. Change and clean protective clothing
at regular intervals.
Take care not to spill either fuel or oil in order to prevent
soil contamination (environmental protection). Clean the
Multi Function Power Head immediately
after fuel has been spilt.
Avoid any fuel contact with your clothing. Change your
clothing instantly if fuel has been spilt on it (to prevent
clothing catching fire).
Inspect the fuel cap at regular intervals making sure that
it can be securely fastened and does not leak.
Carefully tighten the fuel tank cap. Change location to
start the engine (at least 3 meters away from the place of
refuelling).
Never refuel in closed rooms. Fuel vapors accumulate at
ground lever (risk of explosions).
Only transport and store fuel in approved containers.
Make sure the fuel stored is not accessible to children.
Method of operation
Only use in good light and visibility. During the winter
season beware of slippery or wet areas, ice and snow
(risk of slipping). Always ensure a safe footing.
Never cut above waist height.
Never stand on a ladder.
Never climb up into trees to perform cutting operation.
Never work on unstable surfaces.–
Remove sand, stones, nails etc. found within the working
range.
Foreign particles may damage the cutting tool and can
cause dangerous kick-backs.
Before commencing cutting, the cutting tool must have
reached full working speed.
When using metal blades, swing the tool evenly in
half-circle from right to left, like using a scythe.
57
Publicité
