Door Reversal Instructions; Operating Instructions - Danby DWC032A2BDB Guide D'utilisation Et D'entretien

Installation Instructions
DOOR REVERSAL INSTRUCTIONS
1. Remove the two (2) screws from the back of the worktop, lift the back of the worktop slightly and pull the worktop
forward, this will remove the worktop. See Figure 1.
2. Remove the left or right door strip cover (depending on which side you are moving the door to) and the left or right
hinge cover, then remove the two (2) upper hinge screws and remove the upper hinge. Loosen the upper door spindle and
remove the door assembly. See Figure 2.
3. Remove the hinge pin from the door, move it to the other side of the door. See Figure 3.
4. Install the upper door spindle to the opposite side of the upper hinge, place the upper hinge onto the other side of the cab-
inet, install the door strip cover and the hinge cover to the opposite side of where you removed it. See Figure 4.
5. Loosen the adjustable foot and remove the two (2) screws around it. Remove the two (2) bottom hinge screws, remove
the bottom hinge. Reinstall the foot and two (2) screws where the bottom hinge used to be. Install the bottom hinge where
the foot used to be. See Figure 5.
6. Make necessary adjustments to the upper hinge and bottom hinge, reinstall the worktop in reverse order of removing
it.

Operating Instructions

FEATURES
1) Tempered Glass Door: Tinted for UV protection while still
allowing for easy interior viewing.
2) Thermostat Dial: (Externally mounted rear wall thermostat)
For controlling the temperature inside the wine cooler. Turns the
motor (compressor) on /off as soon as the temperature
rises/falls above/below the set cooling level.
3) Magnetic Door Gaskets: Tight fitting seals retain all the
cooling power and humidity levels.
4) Plastic Coated Shelves: Odor resistant, rustproof, and
removable for easy cleaning.
5) Leveling Leg.
6) Interior Light (not shown)
2
4
5
5
1
6
3