Door Swing Reversal - Danby DWC040D2BSSDB Guide D'utilisation Et Soins De Propriètaire

Operating Instructions

DOOR SWING REVERSAL

If you would like to reverse the direction of the door swing, follow the steps below. You will require a
Phillips #2 screwdriver and an adjustable wrench.
1. Close the door and remove rubber screw covers (1), unscrew two screws (2) and remove decora-
tive cover (3). (Fig.1)
2. Unscrew screws (4) and take out top hinge (5), then remove the door. (Fig. 2)
3. Put door aside safely, take out 2 screws (11) at bottom, pull out extrusion-board for lamp switch
(10) and reattach it at the top of the door. (Fig. 3)
4. Pull out plugs (6) from left top of cabinet. (Fig.4)
5. Unscrew 3 screws (7) from right bottom of cabinet and remove lower hinge (8). (Fig.5)
6. Unscrew cabinet leg (9) from left bottom of cabinet and fi x it onto right bottom of cabinet. (Fig.5)
7. Fix the lower hinge (8) onto left bottom of cabinet with screws (7). (Fig. 5)
8. The door revolves 180 degrees, put lower door axis to aim at lower hinge (8) and install the door
onto lower hinge (8), then close the door carefully. (Fig.3)
9. Fix top hinge (5) onto left top of cabinet with screws (4), adjust door and install decorative cover
(3) and rubber cover (1). (Fig.6)
10. Block 3 screw holes at right top of cabinet with spare plugs.
Rubber screw covers
1
2 Screws
3 Decorative cover
4 Screws
Top hinge
5
6 Plug
7 Screws
8 Lower hinge
9 Cabinet leg
10 Extrusion-board for
lamp switch
11 Screws
Fig.1
1
2
3
Fig.4
6
Fig.6
9
Fig.2
4
5
Fig.5
8
7
9
Fig.3
11
10