Danby DWC040D2BSSDB Guide D'utilisation Et Soins De Propriètaire page 14

Troubleshooting
Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary.
Use this troubleshooting guide for a possible solution. If the unit continues to operate improperly, call
an authorized service depot or Danby's Toll Free Number 1-800-263-2629 for assistance.
Problem
No power
Cabinet temperature
is too high.
Condensation on
the cabinet, doors or
fl oor.
Possible Cause
A fuse in your home may be
blown or the circuit breaker
tripped.
Power surge.
Plug not fully inserted into the
wall outlet.
Temperature setting.
Door not shut properly or
opened excessively.
Interior lights toggled on.
Recently added a large quantity
of warm bottles to the cabinet.
High humidity conditions in the
home.
Door not shut properly or
opened excessively.
What to do
Replace fuse or reset circuit
breaker.
Unplug the wine cooler, wait a few sec-
onds and then plug it back in
Make sure the 3-prong plug is fully in-
serted into the outlet.
Verify the temperature control setting.
Adjust if neccessary.
Ensure that the door is fully closed
and that the gasket is sealing against the
cabinets. Open the doors only as needed
and for short periods of time.
The interior lights are intended for
temporary lighting of cabinets for display
purposes only. They are not intended to
be left on for prolonged time periods.
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to stagger the load
introduction if possible.
The condensation will subside once
humidity conditions return to normal.
Ensure that the door is fully closed and
that the gasket is sealing. against the
cabinets. Open the door only as needed
and for short periods of time
11