Door Swing Reversal - Danby DWC040A2BDB Guide D'utilisation Et Soins De Propriètaire

INSTALLATION INSTRUCTIONS
DOOR SWING
REVERSAL
WARNING
To reduce the risk of fi re, burns, electric
shock, or injury to persons when using
your appliance, follow basic precautions,
including the following sections below;
1 Rubber screw covers
2 Screws
3 Decorative cover
4 Screws
Top hinge
5
6 Plug
7 Screws
8 Lower hinge
9 Cabinet leg
10 Extrusion-board for
lamp switch
11 Screws
1. Close the door and remove rubber screw covers (1), unscrew two screws (2) and remove decorative cover (3). (Fig.1)
2. Unscrew screws (4) and take out top hinge (5), then remove the door. (Fig. 2)
3. Put door aside safely, take out 2 screws (11) at bottom, pull out extrusion-board for lamp switch (10) and reattach it at the
top of the door.(Fig. 5)
4. Pull out plugs (6) from left top of cabinet. (Fig.4)
5. Unscrew 3 screws (7) from right bottom of cabinet and remove lower hinge (8). (Fig.5)
6. Unscrew cabinet leg (9) from left bottom of cabinet and fi x it onto right bottom of cabinet. (Fig.5)
7. Fix the lower hinge (8) onto left bottom of cabinet with screws (7). (Fig. 5)
8. The door revolves 180 degrees, put lower door axis to aim at lower hinge (8) and install the door onto lower hinge (8), then
close the door carefully. (Fig.3)
9. Fix top hinge (5) onto left top of cabinet with screws (4), adjust door and install decorative cover (3) and rubber
cover (1). (Fig.6)
10. Block 3 screw holes at right top of cabinet with spare plugs.
TOOLS REQUIRED
Phillips #2 screwdriver and an adjustable wrench.
Fig.1
Fig.4
Fig.2
1
2
3
6
9
Fig.6
5
Fig.3
4
5
11
Fig.5
8
7
10