dirna Bergstrom Bycool Green Série Instructions De Montage page 17

COMPACT 3.0
Position the interior air distribution panel
11
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud. Tighten
the nuts until the interior air distribution panel
duct comes up against the unit's top foam.
Important: The interior air distribution
panel duct must come up against the
unit's upper foam in order to prevent any
leakages of air.
Ø 6 flat washer
Original
edgeband
Cabin roof
Upholstery
Original screw
12
Tighten the nut in point 9 until it comes up
against the top part of the interior air distribution
panel.
13 Present console and centre Compact until
original screws coincide with their original
position.
Ø 20 x Ø 7 x 3 rubber washer
9
A
M6 nut
M6 nut
M6 stud
Console
11
Foam
Adjust canalisation systems against base joint
13
17
EN
®
Scheme A