Publicité
Les langues disponibles
Les langues disponibles
STARTING A WASH CYCLE
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
• Ensure that they are clean and properly positioned. See the section Cleaning and Maintenance.
4. Check that there is rinse aid and salt.
5. Load the dishes.
• Ensure that the spray arms can rotate freely.
6. Add the required amount of detergent into the dispenser according to the Washing Program chart.
7. Press
to switch on the dishwasher.
8. Press the desired program button to select the desired washing program.
• The corresponding indicator light on the selected button will illuminate.
• Delay Timer: The delay timer allows you to delay the start of a washing program from 1 hour up
to 24 hours.
Repeatedly press
9. If you want to activate other functions, press the desired function button.
10. Press
or
11.
Press
and clo
se the door . The dishwasher will start a cycle.
12. After the program has ended, the diswasher will buzz and stop.
13. Wait for 15 minutes before you open the dishwasher door in order to avoid burns.
14. Unload the dishes.
WARNING!
• The washing cycle will not start if the dishwasher door is left open or not properly closed.
• Do not open the door when the dishwasher is working since hot water may be ejected, which could
cause scalding.
Adding extra dish
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow
the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door. The cycle will start from the point at which it was interrupted.
Changing the program in progress
A wash cycle can only be changed if it has been running for a short time otherwise, the detergent may
have already been released and the dishwasher may have already drained the wash water. If this is the
case, the dishwasher needs to be reset and the detergent dispenser must be refilled. To reset the
dishwasher, follow the instructions below:
1. Open the door a little to stop the washing. After the spray arms stop working, you can open the door
completely.
until the desired delayed start time is shown on the display.
to select the upper or lower basket to be sprayed during a washing cycle.
3 sec
GB-23
Publicité
