EUROM Vento Manuel D'utilisation page 18

Switching on
Press briefly on the On/Off button and the fan will start operating at a quiet fanning
speed.
Adjusting the fan speed with sufficient battery power
On/Off Fan speed
button
Press 1x Quiet
Press 2x Low
Press 3x Medium
Press 4x High
The fan operates with too little battery power
Fan speed
Quiet
Low
Medium
High
Switching off
Press 3 seconds on the On/Off button and the fan will switch off immediately,
regardless of the fan speed.
Charging
1. The Cordless Fan is delivered without a USB mains adapter. Internal battery of
the Cordless Fan can be charged in three different ways:
Via 220/240 Volt 50 Hz socket:
-
Use a USB mains adapter, which is intended for use in a household socket
of 220-240 Volt / 50 Hz and an output voltage of maximum 5 Volt to
produce a charging capacity of maximum 1 Ampere. Never use a mains
adapter with other voltages. The connection voltage and frequency, stated
on the USB mains adapter (not provided), must correspond to those in the
socket that you use and the electrical installation must be equipped with a
residual-current circuit breaker van 30mA.
Via a USB A port (5 Volt):
-
The battery of the Cordless Fan can also be charged by attaching the
charging cable directly to a USB A port.
Via a USB car charger (the connection for cigarette lighters):
-
LED lamp
On
On
On
On
LED lamp 1
5x blinking Off
then off
5x blinking 5x blinking
then off then off
5x blinking 5x blinking
then off then off
5x blinking 5x blinking
then off then off
LED lamp
1 2
Off
On
On
On
LED lamp 2
Off
Off
5x blinking
then off
5x blinking
then off
18
LED lamp
3
Off
Off
On
On
LED lamp 3 LED lamp 4
Off
Off
Off
5x blinking
then off
LED lamp
4
Off
Off
Off
On