Technical Specifications - LAVAZZA MilkUp Mode D'emploi

Problem encountered Possible causes
The milk frother does
not switch on. Warning
light off after
having pressed the
multifunction button.
The milk frother does
not froth the milk.
Poor quality milk froth.
Red flashing light
Milk leaking from the
container.
Milk cold.
Too hot or burnt milk.
The milk frother is noisy.
• Nominal Voltage - Power Rating - Power Supply:
See label on the appliance
• Measurements: Height
230 mm 205 mm 130 mm
• Weight: approx. 1 kg
• Milk container: Max 180 ml - Removable
TROUBLESHOOTING
» Appliance not connected to
the electricity grid.
» Smooth or notched crown not
present in the milk container.
» Components are inserted
incorrectly.
» The milk container is dirty.
» Incorrect quantity of milk.
» Unsuitable milk.
» Appliance overheated.
» Components installed
incorrectly or blocked.
» Presence of foreign bodies.
» Incorrect quantity of milk.
» Components installed
incorrectly.
» Button pressed incorrectly
» Incorrect quantity of milk.
» Components missing
» Components installed
incorrectly
» Presence of foreign bodies.

TECHNICAL SPECIFICATIONS

Width Depth
Solution
» Make sure that the power lead is properly plugged in.
» Contact customer service.
» Make sure that the notched crown, and potentially the
smooth one, are correctly positioned inside the milk
container.
» Make sure that the right crown is used to prepare the
milk desired.
» Make sure that the milk container is clean.
» Make sure that the correct quantity of milk has been
used, respecting the levels shown.
» Make sure that whole or semi-skimmed milk at
refrigerator temperature (approximately 6-8°) is used.
» The appliance is too hot. Rinse the milk container with cold
water and fill it with cold milk.
» Hot milk has been placed into the milk container. Rinse the
milk container with cold water and fill it with cold milk.
» Make sure that the milk container has been inserted in
the correct position and that there are no obstructions or
foreign bodies inside its housing.
» Make sure that the notched crown, or both crowns, have
been inserted correctly into the milk container.
» Make sure that the rotation of the notched/smooth crown is
not blocked by dry milk or chocolate residues.
» Make sure that the correct quantity of milk has been
used, respecting the levels shown.
» Make sure that the right crown is used to prepare the milk
desired.
» Do not hold the button down to prepare hot frothed milk,
simply press the button and release.
» Make sure that the milk is not below the MIN level.
» Make sure that the correct crowns have been inserted.
» Make sure that the crown has been inserted correctly.
» Make sure that the lid is properly fitted into place.
» Make sure that the appliance is on a stable top.
» Make sure that there are no foreign bodies in the cup.
• Housing materials: Thermoplastic
• Cable Length: 0,6 m
• Magnetic induction heating system
EN