Technical Specifications - LAVAZZA CLASSY MINI Mode D'emploi

N° Problem encountered
11 The coffee is cold.
Dispensed coffee is insufficient
12
or excessive.
Coffee not supplied and steam
13 coming out of the capsule
compartment.
14 Coffee pours out in drops.
One of the two buttons is not
15 working and the relevant LED
is off.
As regards the faults not covered by the above table, or if the suggested actions do not remedy the faults,
• Power supply: 120V / 60Hz
• Nominal power: 1250 W
• Water tank capacity: 0,7 L (23,66 oz) - Removable type
• Weight: 3,5 kg (7,7 lb)
TROUBLESHOOTING
Possible causes
1 - Coffee pours out in drops,
water circuit clogged.
2 - The machine has lime
scale build-up.
1 - Coffee pours out in drops,
water circuit clogged.
2 - The machine has lime
scale build-up.
1 - The loading lever was
not set to the brewing
position.
1 - Faulty capsule.
2 - Pump working improperly.
3 - Spout/water circuit
clogged.
4 - The machine has
limescale build-up.
1 - Mechanical blocking.
contact the nearest Lavazza Authorized Service Centre.

TECHNICAL SPECIFICATIONS

Solution
Run the machine washing cycle.
De-scale the machine.
Run the machine washing cycle.
De-scale the machine.
Set the loading lever to the
brewing position.
Replace the capsule.
Check for abnormal noise of the
machine.
Clean the coffee dispensing
spout
(see MAINTENANCE AND
CLEANING).
De-scale the machine.
Try to power the machine off by
disconnecting the power plug
for 10 seconds then reconnect
it. Power the machine on and
check the correct operation of
both buttons.
If the problem persists, the
machine can continue to be
used with the other button; in
this case, the button working
regularly will no longer have the
automatic dosing but will be free
dosing, and the user will decide
when stopping the dose.
• Materials used for the body: thermoplastic
• Size: Height 26 cm - Width 13,5 cm - Depth 34 cm
Height 10,2 in - Width 5,3 in - Depth 13,3 in
• Thermo fuses
EN
Result
OK: call solved.
Non-OK: go to step 2
OK: call solved.
Non-OK: machine being serviced
OK: call solved.
Non-OK: go to step 2
OK: call solved.
Non-OK: machine being serviced
OK: call solved.
Non-OK: machine being serviced
OK: call solved.
Non-OK: go to step 2
OK: call solved.
Non-OK: go to step 3
OK: call solved.
Non-OK: go to step 4
OK: call solved.
Non-OK: machine being serviced.
OK: call solved.
Non-OK: machine being serviced
15