Additional Information - Pioneer XPRS Série Mode D'emploi

Additional Information

Troubleshooting
! If you think you are experiencing a malfunction with this unit, check the following items. Also check other devices connected to the unit. If the problem
persists, consult your dealer for service.
! On occasion, the unit may fail to operate properly due to static electricity or other external conditions. In this event, disconnect the power cord and
wait for five seconds or more, then reconnect the power cord and check for proper operation.
Symptom
No power
No sound from connected audio
devices, or sound is very small.
Sound is distorted, or the LIMIT
indicator is lit.
Howling (feedback effect)
Items to Check
Is power cord connected properly?
Has connected audio device been set
properly?
Is connection cable connected properly?
Are connectors or plugs dirty?
Is sound level set properly?
Is the power turned ON?
Is the GAIN selector set appropriately?
Is the volume set to the correct position?
Is the output signal level of the connected
equipment set appropriately?
Is the output signal of the connected
equipment distorted?
Microphone is pointed toward speaker.
Are the microphone and speaker too close?
Is the volume set to the correct position?
Remedy
Connect power cord to outlet (page 6).
Set device's ouput selector and sound volume
properly.
Connect cables properly (page 7).
Clean connectors and plugs before connecting.
Turn the MASTER LEVEL knob on the rear panel
of the speaker slowly to the right to increase the
volume.
Turn on the POWER switch on the rear panel of
the speaker.
Check that the GAIN setting on the rear panel is
appropriate (page 3).
Turn the MASTER LEVEL or INPUT LEVEL control
on the rear panel counterclockwise to reduce
the volume until the LIMIT indicator turns off.
Adjust the output level of the connected
equipment.
Check the instruction manual of the connected
equipment.
Change the orientation of the microphone.
Move the microphone away from the speaker.
Turn the MASTER LEVEL or INPUT LEVEL control
counterclockwise to reduce the volume.
9
En