Pioneer XPRS Série Mode D'emploi page 6

Installation Using the Rigging Points on the Speaker
! The full-range models have suspension-mounting rigging points on
them. The speaker can be suspended using commercially-available
eye bolts. The rigging point has an M10 screw hole (for an eye bolt with
a thread length of 30 mm to 50 mm).
! When installing the speaker suspended, ask a qualified technician to
perform the work.
! Remove the screws from the rigging points on the speaker and attach
eye bolts. Do not use the speaker while the screws are removed. The
sound will be adversely affected by air leakage.
! Be sure to use at least three rigging points to suspend the speaker.
Furthermore, be sure to also implement an extra safety measure such
as using a wire.
! Use brackets, wires, and a wall or ceiling strong enough to bear the
weight of the speaker. Ask for commercially-available brackets at the
shop where you purchased the speaker.
! Be sure to confirm the safety after installing the speaker and
periodically thereafter.
Casters of the subwoofer model
! The subwoofer model comes with casters that allow you to easily move it around.
! To use it as a fixed installation, you can remove the casters.
! When using it with the casters removed, be sure to put back the caster fixing screws.
If you use it with the screws removed, the sound quality will be affected by air leakage.
EQ MODE Settings
Four EQ modes (FLAT, BASS+, SPEECH, and WEDGE) are available for the full-range models. EQ MODE can be selected from four
options using the [EQ MODE SELECT] switch. Select the best mode according to your preferences and the usage situation.
FLAT
Reproduces the input sound faithfully. (Factory default setting)
BASS+
This setting increases the presence of low frequencies and reproduces powerful dance music at a club, etc.
SPEECH
This setting emphasizes the voice frequencies to make it easy to listen to the voice of a lecturer, etc.
WEDGE
This setting suppresses the excessive boost in the low frequencies that occurs when the speaker is installed on the floor surface as a
floor monitor.
Connections
When making or changing connections, always turn off the power and disconnect the power cord from its outlet.
Also, be sure to read the operating instructions for the other components to which you are connecting these speakers.
Do not connect the power cord until all other connections are completed.
Use only the furnished accessory power cord.
6
En
:Caster
:Rigging points
:M5 hex screw (thread length 25 mm)