Preparation And Sequence Of Operation - M+W Dental SUPERLITE POWER PEN Mode D'emploi

M+W Superlite Power Pen/Color Pen.
Warranty for the device does not cover any damage resulting from the use on non-original
replacement parts. The device or any of its parts should not be disassembled while it is still connected to the mains!
9. aTTENTION FRaGILE! Be extremely careful during transportation, storage and handling of the device!
10. Pursuant to Directive 2002/96/EU, this symbol shows that the product must not be disposed of as urban waste at the end of
its operating life. Devices removed from service must be taken to centres specialised in separate collection of electric and electronic equip-
ment. Correct disposal of equipment which is no longer used, prevents negative consequences for the environment and human health!
11. Prior to every application, the light conductor, the glare protection shield and the light protection cap should be prepared according to
the recommendations in VI. Care and maintenance.
12.Heat generation
as with all high performance lamps, the high light intensity involves heat generation. Irreversible damage can occur in the region near the
pulp or soft tissues during prolonged exposure.Therefore, the prescribed exposure times in the region near the pulp (adhesive 10 seconds)
are to be observed. Uninterrupted exposure times of more than 20 seconds on the same tooth surface as well as direct contact with the gin-
giva, oral mucosa or skin are to be avoided under all circumstances. In the case of indirect restorations, work should be performed with in-
termittent intervals of 20 seconds or via external cooling with air flow.
V. Preparation and sequence of operation
1. Remove M+W Superlite Power Pen/Color Pen from the packaging.
2. Connect power adaptor to mains to charge the battery.
Attention! The device should be placed at least 1 metre away from any heat source.
3. Prior to being used for the first time, the light conductor, the glare protection shield
and the light protection cap should be prepared according to the recommendations in
VI. Care and maintenance.
2
Then re-attach light protection shield or light protection cap.
The light protection cap is suitable for polymerisation in the posterior dental region,
the light protection shield is suitable for the anterior dental region.
3
14