Domo DO1017 Mode D'emploi page 31

PARTS
1. Observation window
2. Glass tray
3. Safety interlock system
4. Turntable shaft
5. Turntable ring assembly
6. Knob for opening door
7. Control panel
8. Protection cover wave guide - never
remove this cover!
BEFORE THE FIRST USE
· Remove all packaging material and accessories.
· Clean the appliance in accordance with the 'cleaning and maintenance' instructions.
TURNTABLE INSTALLATION
· First place the turntable ring in the middle of the microwave oven.
· Place the turntable on the ring. Make sure that the middle of the
turntable fits into the turntable shaft.
CAUTION:
· Never place the glass tray upside down. The glass tray should never
be restricted.
· Both glass tray and turntable ring assembly must always be used during cooking.
· All food and containers should be placed onto the glass turntable during cooking at all times.
· If the glass tray or turntable ring assembly cracks or breaks, contact your nearest authorized service
center.
INSTALLATION
· Check the oven for any damage, such as dents or a damaged door. Do not use the oven if it is
damaged. Remove the protective film
around the machine, this is applied to
avoid scratches.
· Choose a place to install the
microwave, where there is sufficient
open space for the air intake and
exhaust. The microwave oven must
stand at least 85 cm high. Make sure
that the left and right side are at least
www.domo-elektro.be
Waveguide
3
8
Cover
1 2 4 5 6 7
31
DO1017