Husqvarna ST 224 Manuel D'utilisation page 19

1. Loosen the jam nuts (B) next to the turn buckle
(A) to adjust the cable tension in the auger
control cable (D). (Fig. 79)
2. Hold the short section and turn the long section.
Turn it 360 degrees.
3. Test the auger engagement. Repeat the
adjustment until only a small amount of tension
remains in the cable when the lever is
disengaged.
4. Tighten the bottom jam nut to lock in the tension.
5. Ask an assistant to stand 10 feet / 3 meters
in front of the product, on the opposite side of
the chute. The assistant observes the rotation
of the auger and measures the time it takes
for the auger to stop rotating after the lever
is released. If the auger stops rotating after 5
seconds, adjust the cable by rotating the center
barrel 360 degrees, to contract the adjuster. Test
the auger engagement and measure the stop
time again. If the auger stops rotating in less than
5 seconds, continue with the next step.
2069 - 002 - 11.08.2023
6. Tighten the jam nut on the auger cable.
Note:
If the adjustment does not resolve the
problem, replace the auger belt. See
the auger belt on page 18 .
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin
(B).
2. Remove the wheel from the axle (C). (Fig. 80)
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
To remove
19