Ryobi TSS103 Manuel D'utilisation page 26

 Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the trigger lockout
lever and squeeze the switch trigger. Allow several sec-
onds for the blade to reach maximum speed.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.
TO SUPPORT LONG WORKPIECES
See Figure 33.
Long workpieces need extra supports. Supports, roller stand,
or work surface level with the saw table should be placed
along the workpiece so it does not sag. The support should
let the workpiece lay flat on the base of the saw and work
table during the cutting operation. Use the work clamp,
C-clamp, or other suitable clamp to secure the workpiece
when possible.
WARNING:
Never make a cut by pulling the saw toward you as
the blade can climb on top of the workpiece and come
toward you. Failure to heed this warning could result in
serious personal injury.
TO SLIDE CUT
See Figures 34 - 35.
The sliding feature will cut workpieces 12 in. wide by 1-1/2 in.
thick or 3-1/2 in. wide by 3-1/2 in. thick. With the saw off,
pull the saw arm forward. Turn the saw on (let blade reach
maximum speed), push the blade down cutting into the
workpiece then back toward the rear of the saw to make a
cut. Cuts are made by pushing the saw blade away from you
and toward the bevel scale at the back of the saw stopping
when the full rear position has been reached after each cut.
When the saw is running (turned on), NEVER pull the saw
blade toward you or toward the front of the saw.
 Raise saw arm to its full height.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the fence, the board could
collapse on the blade at the end of the cut, jamming the
blade. See Figures 40 - 41.
 When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 33.
OPERATION
LONG
WORKPIECE
 Turn the LED switch on.
 Lower the blade and align the cutting line on the workpiece
with the edge of saw blade or the blade shadow.
 Loosen the slide lock knob by turning the knob counter-
clockwise.
26 − English
WORKPIECE SUPPORTS
SLIDE CUT
SLIDE LOCK
KNOB
Fig. 33
SLIDE SAW ARM
FORWARD THEN
PUSH DOWN
Fig. 34