Nordcap ABS Série Manuel D'utilisation page 10

Operation
Temperature setting and control (EVCO)
The front panel of the thermostat
1. Compressor operation light
2. Defrosting light
3. Energy saving light
4. Stand-by light
5. Programming key (service agent only)
6. Machine On/Stand -by (keep pushed)
7. Manual defrost (keep pushed)
How to unlock the keyboard (»Loc» message)

Push any button for more than 2s, «UnL» message will appear and the keyboard will be
unlocked.
Note: For safety reasons the keyboard locks automatically after 30s of keys inactivity.
To execute any operation, please unlock the keyboard first.
How to see and modify the set point

Push and immediately release the
blinking;

To change the set value push

To memorize the new set point value push the
Automatic defrost

The appliance will automatically run defrost cycles.
Note: the cycle starts from the time the appliance is initially powered up.
To manually defrost the applicance:

Press and hold the DEFROST

The defrost cycle will start immediately and the Defrost
Note: Starting a manual defrost also resets the automatic defrost timer. The next automatic defrost
will start according to the set parameter after the manual defrost has finished.
How to turn the machine in ON / STAND -BY status

Press and hold the
vice-versa.

During the button hold the
GB
key, the set point will be showed and
or arrows within 20s.
button for 3s;
key for 4s, the machine will turn from ON to STAND -BY status and
LED will blink to show status changing.
10
key again or wait 20s .
LED illuminates.
P2M031STD - Ver.1.0
starts