Operation - Electronic Control Unit; Operation - Getting Started - EGO PECM01 Guide D'installation

Operation - Electronic Control Unit

The Electronic Control Unit (32), which is mounted inside your caravan, is responsible for controlling the Ego mover.
The control unit has three LED's (Fig.3b) and one recessed button (Fig.3a):
Green LED – This will illuminate when receiving the signal. The LED will flash if the remote control is out of range (the
maximum range is 100 metres – without obstruction).
Blue LED – This will illuminate if the temperature of the control unit is too high, or if the battery voltage is
too low or too high.
The Red LED will specify the error as follows:
Red LED – Voltage too low <10V: LED will flash twice slowly.
Voltage too high >15V: LED will flash fast 5 times.
Electric current is too high (≥120A): LED will constantly flash.
Temperature is too high >80C: LED is on permanently.
Reset Button (Fig.3a) – This only needs to be used when replacing a remote control handset. Press the button, the green
LED will flash for 10 seconds. Press the power button on the handset twice whilst the Control Unit's LED is still flashing.
The green LED will then be on without flashing. The remote control and Control Unit are now paired. Because they are
uniquely paired, the remote control cannot operate another mover system. All error messages will reset automatically
after 40 seconds. If this does not occur, reset the mover by switching off the mover via the isolator switch for
at least 10 seconds and turn it on again. Then re-establish the connection with the remote control (by pressing the
power button on the handset twice within 1 second).
When the Control Unit is connected to power, it will perform a self-test automatically. The 3 LEDs will illuminate for 0.2
seconds, and turn off, which means there is no error and the unit is functioning correctly.
As a safety feature the Control Unit will switch off automatically if no button is pressed within 60 seconds. The Control
Unit will also turn off automatically if the mover is working constantly in one direction for longer than 3 minutes.

Operation - Getting Started

Please make sure you read the safety instructions very carefully and make sure that you follow these guidelines!
Make sure that the battery that supplies the mover is fully charged and in good condition.
Make sure that the caravan is free from the vehicle and the handbrake is on. Also make sure that the corner-
steady feet are fully raised.
Engage both rollers as described in 'Operation-Motor Units'. This only needs to be done on one side of your caravan
since the other side will automatically follow via the cross actuation bar.
Turn on the Battery Power Isolation Switch (29).
Before operating the Mover, release the handbrake.
Activate the Ego Mover by double-clicking the power button (Fig.5a) on the remote control. The LED (Fig.5h) on the
remote control will illuminate.
Now you can choose the movements according the symbols shown on the remote control.
Straight forward (Fig.5b), straight reverse (Fig.5c), left forward (Fig.5d), left reverse (Fig.5f), right forward (Fig.5e), right
reverse (Fig.5g). In addition, the 'left forward' and 'right reverse' buttons or 'right forward' and 'left reverse' buttons may
be pressed at the same time to turn the caravan around on its own axis (without moving forward or backward).
As soon as the buttons are released the caravan will stop
Ego Page UK-7
Ref: PECM01-UM-0110-Rev.A.