Publicité
Les langues disponibles
Les langues disponibles
TROUBLE SHOOTING
Problem
1. Mower doesn't run when switch
lever is activated.
2. Motor stops while mowing.
3. Mower runs but cutting perfor-
mance is unsatisfactory, or does not
cut entire lawn.
4. Mower is too hard to push.
5. Mower is abnormally noisy and
vibrates.
6. Battery charger LED's not on.
24V 14" Cordless lawn mower
All manuals and user guides at all-guides.com
A. Check to make sure safety key has been installed and
is fully seated and that button on switch housing is be-
ing completely pushed.
B. Release switch lever to turn mower off. Remove
safety key, turn mower over and check that blade is
free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
C. Has battery been fully charged? Plug in charger and
wait for green light to come on.
A. Release switch lever to turn mower off. Remove
safety key, turn mower over and check that blade is
free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
B. Raise cutting height of wheels to highest position and
start mower.
C. Has battery been fully charged? Plug in charger and
wait for green light to come on.
D. Avoid overloading the mower. Slow down the cutting
pace by pushing mower slower or raise the cut height.
Or both.
A. Has battery been fully charged? Plug in charger and
wait for green light to come on. "
B. Release switch lever to turn mower off. Remove
safety key. Turn mower over and check: Blade for sharp-
ness - Keep blade sharp. Deck and discharge chute for
clogging.
C. Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass.
Check each wheel for free rotation.
A. Release switch lever to turn mower off. Remove safe-
ty key. Turn mower on side and check blade to ensure
it has not been bent or damaged. If blade is damaged,
replace with a replacement blade. If the underside of the
deck is damaged return mower to a Authorized service
center.
B. If there is no visible damage to the blade and the
mower still vibrates: Release switch lever to turn mower
off, remove safety key and remove blade. Rotate blade
180 degrees and retighten. If mower still vibrates, return
the mower to an authorized service center.
A. Check plug connection.
B. Replace charger.
Solution
19
19
EN
Publicité
