Samsung RF28R7201SR Guide D'utilisation page 39

Autofill Pitcher
Untitled-1 39
If the Lock indicator ( ) is off, press and hold Fridge for 3
seconds to turn Autofill Pitcher on. Then, open the left door of the
fridge and insert the water tank. Close the door and the water
tank starts to fill with water up to the preset level.
If the Lock Indicator ( ) is on, indicating Control Lock is active,
press and hold Door Alarm for 3 seconds to deactivate Control
Lock. When the Lock indicator goes out, immediately press and
hold Fridge for 3 seconds to turn Autofill Pitcher on. Then, open
the left door of the fridge and insert the water tank. Close the
door and the water tank starts to fill with water up to the preset
level.
NOTE
When you turn off Control Lock, you must press and hold Fridge
within one minute or the Control Lock function will automatically
reactivate. You cannot turn the Autofill Pitcher function on if
Control Lock is active. For more information on Control Lock, see
page 43.
To turn the function off, press and hold Fridge again for
3 seconds.
NOTE
• By default, Autofill Pitcher is disabled. Enable this function
after you have installed the water line.
• If you open the door or push the dispenser lever, this function
is stopped temporarily.
• The Autofill Pitcher indicators blink if there is a leak. This may
occur because the water pitcher overflows, or the water-line or
water-level sensor fails. If this is the case, follow these steps.
a. Open the rubber cap and drain water.
b. When draining is complete, the indicators stop blinking and
turn solid.
c. Close the rubber cap.
• If the indicators continue to blink, this might be a system
failure. Contact a local service center.
English 39
2021-05-21 4:47:16