Samsung RF28R7201SR Guide D'utilisation page 35

NOTE
Only connect the water line to a potable water source.
• If you have to repair or disassemble the water line, cut off
make sure you get a snug, leak-free connection.
• You can test the water line quickly using a paper cup. Under normal conditions, the
water dispenser can fill a 5
STEP 8 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1. Plug the power cord into the wall socket to turn the refrigerator on.
2. Open the door, and check if the interior light lights up.
3. Set the temperature to the coldest setting, and wait for about an hour. Then, the freezer
will be slightly chilled, and the motor should be running smoothly.
4. Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready
for use.
STEP 9 Final check
When installation is complete, confirm that:
• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat, level surface with a reasonable clearance from
walls and cabinets.
• The refrigerator is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when you
open the door.
Untitled-1 35
/ oz. (170 cc) cup in about 10 seconds.
3
4
1
/ " of the plastic tubing to
1
4
CAUTION
Before installing the refrigerator, make sure
to remove the Cover Interlock (1) from the
top of the fridge door. Otherwise, injuries
may be caused by the ice crushing blade.
English 35
2021-05-21 4:47:16