Publicité
Les langues disponibles
Les langues disponibles
ENglisH
Dry pick up
For everyday spills of dry material.
- Do not fill the dust bowl
intake chute.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product
Removing the dust bowl and filter (Fig. D–F)
WARNING:
should be cleaned regularly.
1. Press the bowl release button
bowl
straight off as shown in Fig. D.
3
2. While holding the dust bowl over a trash can, pull out
the filter
,
/
to empty the contents as shown in
10
11
12
Fig. E and F.
3. Insert cleaned filter
10
4. To replace the dust bowl, push it back onto the handle
until it clicks firmly into place.
WARNING:
without the filters. Optimum dust collection will only be
achieved with a clean filter.
Bag filter and pre-filter (Fig. G, H)
HNVC220BCZ00W
The bag filter and pre‑filter can be separated to allow for
better cleaning.
Twist the bag filter to separate it from the pre‑filter.
Cleaning the dust bowl and filter
The dust bowl and filter can be washed in warm
soapy water.
1. Make sure the filters and the dust bowl
before installing.
Accessories (Fig. I, J)
Your hand vac may be supplied with some of the
following accessories:
- A brush tool
for furniture and stairs.
7
1. A crevice tool
13
is built into the dust bowl and can
be extended as shown in Figure I by pulling the extension
piece until it locks into position.
2. To store the crevice tool, press the release button
and push the crevice tool
in Figure I.
Fitting
1. Insert the appropriate accessory into the front of the dust
bowl
3
as shown in Figure J.
2. Make sure the accessory is fully pushed in.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described in Emptying and
cleaning the product and Cleaning the dust bowl and filter.
• Fit the new filters as described in Emptying and cleaning
the product and Cleaning the dust bowl and filter.
(cat. no: HNVCF10)
6
3
beyond the end of the
The filter is reusable and
and pull the dust
2
back into the dust bowl
Never use the appliance
3
are dry
into the dust bowl as shown
13
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
WARNING:
completely dry before using it.
iMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than
those listed in this manual) should be performed by
BLACK+DECKER authorized service centers or other
qualified service organizations, always using identical
replacement parts.
TROUBLESHOOTING
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels
.
slightly warm to the touch.)
3
• The charger cord is not damaged and is
correctly attached.
• The charger is plugged into a working electrical outlet.
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service
center nearest you or call the BLACK+DECKER help line at
1–800–544–6986.
Battery Removal and Disposal
This product uses Lithium Ion rechargeable and recyclable
batteries. When the batteries no longer hold a charge, they
should be removed from the vacuum and recycled. They
must not be incinerated or composted.
The batteries can be taken for disposal to a BLACK+DECKER
Company‑Owned or Authorized Service Center. Some local
retailers are also participating in a national recycling program
(see "RBRC® Seal"). Call your local retailer for details. If you
bring the batteries to a BLACK+DECKER Company‑Owned or
Authorized Service Center, the Center will arrange to recycle
old batteries. Or, contact your local municipality for proper
disposal instructions in your city/town.
To remove the battery pack for disposal:
1. First, before attempting to disassemble the product,
turn it on and leave it on until the motor completely stops
insuring a complete discharge of the batteries.
2. Using a hex screwdriver, remove the seven screws
14
securing the two housing halves.
3. Lift the housing cover away from the assembly.
4. Detach all lead connections from battery pack.
5. Remove battery pack and dispose of as per
recommended guidelines.
Accessories
WARNING:
than those offered by BLACK+DECKER, have not been
tested with this product, use of such accessories with this
product could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be used
with this product.
Recommended accessories for use with your product
are available at extra cost from your local dealer or
authorized service center. If you need assistance in locating
any accessory, please contact BLACK+DECKER. Call
1‑800‑544‑6986.
Make sure the vacuum is
Since accessories, other
Publicité
