Publicité
Les langues disponibles
Les langues disponibles
f ) Do not use a battery pack or appliance that is
damaged or modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion or
risk of injury.
g ) Do not expose a battery pack or appliance to fire
or excessive temperature. Exposure to fire or temperature
above 266 °F (130 °C) may cause explosion.
h ) Follow all charging instructions and do not
charge the battery pack or appliance outside of the
temperature range specified in the instructions. Charging
improperly or at temperatures outside of the specified range
may damage the battery and increase the risk of fire.
i ) Have servicing performed by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the product is maintained.
j ) Do not modify or attempt to repair the appliance or
the battery pack except as indicated in the instructions
for use and care.
k ) Only for use with the SSC‑080015US /
S003BEU0800015 chargers.
Additional Safety Information
WARNING:
or any part of it. Damage or personal injury could result.
• Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
Direct particles away from face and body.
• Air vents often cover moving parts and should be
avoided. Loose clothes, jewelry or long hair can be caught in
moving parts.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
OPM .................... oscillations per
minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
Wh ...................... watt hours
Ah ....................... amp hours
or AC ........... alternating current
Never modify the appliance
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
PSI....................... pounds per square
inch
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation–
do not stare into
the light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
..................... do not expose to
rain
The RBRC® Seal
Please take your spent battery packs to an
authorized BLACK+DECKER service center
or to your local retailer for recycling. In
some areas, it is illegal to place spent
battery packs in the trash. You may also contact your local
recycling center for information on where to drop off the
spent battery pack. Do not place in curbside recycling. For
more information visit www.call2recycle.org or call the
toll‑free number in the RBRC® Seal.
RBRC® is a registered trademark of Call 2 Recycle, Inc.
ASSEMBLY
WARNING:
repair the appliance.
Wall Mounting (Fig. B)
The product can be attached to a wall to provide a
convenient storage and charging point for the appliance.
When mounting to a wall, make sure the mounting method
is suitable for the wall type and is appropriate to the weight
of the appliance.
1. Mark the location of the base charger screw holes
the wall (within reach of an electrical outlet for charging the
vacuum while it is on the wall bracket).
2. Fix the base charger to the wall using appropriate screws
and plugs for the type of wall, and weight of the appliance.
3. Hang the appliance by placing the opening of the
vacuum base over the hook
Charging the battery (Fig. A)
WARNING:
supplied charger.
WARNING:
empty all contents and dry thoroughly if needed to avoid
damage to your appliance.
1. Before first use, the battery must be charged for at least
10 hours.
2. Place the appliance on the charging bracket whenever it
is not in use.
3. Make sure the appliance is switched off.
4. Place the appliance on the base charger
5. Plug in the charger
5
6. Leave the appliance to charge for at least 9 hours.
NOTE: While charging, the charger may become warm. This
is normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
WARNING:
at ambient temperatures below 39 °F (4 °C) or above
104 °F (40 °C).
Charging Indicator LED
1. While charging, the red LED on the charger
will illuminate.
2. When charging is completed, the red LED will turn off.
Switching On (Fig. C)
1. To switch the appliance ON, press and hold the
On/Off button
1
.
2. Once the button is released the vacuum will turn Off.
Do not attempt to modify or
9
on the base charger.
For use only with the
Before charging, be sure to
6
.
.
Do not charge the battery
5
ENglisH
on
8
5
Publicité
