Publicité
Les langues disponibles
Les langues disponibles
9. PC connection
•
The receiver can hold up to 4,080 weather data entries (with date and time) in its internal memory. This
memory is non-volatile (EEPROM) and will be preserved in case of a power failure (e.g. battery
replacement). When memory is full, the oldest data sets are overwritten.
•
It is possible to read, copy, store and print this memory data by connecting the receiver to a PC (not incl.)
running the appropriate software.
Minimum system requirements
operating system: Windows NT4 (SP 6a), 2000, XP, Vista, 7
web browser: Internet Explorer 6.0
processor: Pentium III, 500MHz
memory: 128MB (256MB recommended)
CD ROM drive + free USB port
Software installation
•
Place the included CD ROM into the reader of a suitable computer. Do not connect the receiver yet.
•
When the auto-run feature on the PC is enabled, follow the instructions on the screen. If not, open the drive,
locate the file setup.exe and double click it.
Note: make sure you are logged on to the system with an administrator account when installing or running
the software.
•
Select the installation language and click next.
•
Click next and select the destination folder (change directory when desired).
•
Click next and the software will be installed automatically.
•
Press OK to finish the installation process.
•
When required, restart the computer.
•
Plug the included USB cable into the USB port on the receiver (left side) and plug the other end into the USB
port of the computer.
Software use
•
Prior to using the software, make sure the time set on the base station and the PC is the same. This to avoid
time discrepancies between actual recording time and the time shown on the PC.
•
To start the EasyWeatherPlus software, go to "Start—All Programs—EasyWeahterPlus" and click on the
"EasyWeatherPlus" icon.
Note: run the program under an administrator account.
•
The computer starts to download all data on the weather station. This might take a few minutes to
complete. Do not attempt to change settings during this download or the data transfer will fail.
•
Set the interface language via the Display – Language option.
setup
(System – Setup)
display min. and max. history values
(System – Scope)
display graph data
(Record – Graph)
02.02.2011
WS3080
system alarm settings
(System – Alarm)
display history
(Record – History)
about EasyWeatherPlus
(Help – about EasyWeatherGraph)
11
©Velleman nv
Publicité
