PCWork PCW01A Mode D'emploi page 9

•
Never look directly into the LED flashlight of the device. Non-compliance bears the
risk of permanently damaging your eyesight.
•
Please comply with the local and national safety code. Wear personal protection
equipment to prevent any injury through being exposed to electrical shock or
electrical arc caused by an exposed hazardous live conductor.
•
When low battery is indicated, please replace the battery in time to prevent of any
measurement error.
•
Do not use the instrument around explosive gas, steam, or in an wet environment.
•
When using the probe, please put your fingers behind the finger protector of the
probe.
•
When measuring, please connect the zero (neutral) line/ ground line first, then
connect the live wire; when measuring is done, please disconnect the live wire first,
then disconnect the zero (neutral) line / ground line.
•
Before opening the outer cabinet or the battery cover, please remove the probes
from the device. Do not use the device, when it is taken apart or the battery cover
is open.
•
The safety standards are only met when the instrument is used together with the
supplied probes. If the probes are damaged and need to be replaced, only use
probes with the same model number and the same electrical specifications for
replacement.
9