Ego Power+ ST1500-FC Guide D'utilisation page 12

MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE
WARNING:
assembling parts, making adjustments, cleaning, or when the product is not in use.
1. Remove the battery pack from the trimmer.
2. Loosen the four screws in the
handle with a Phillips screwdriver
(available separately) and remove
the screws and the lower clamp
from the handle (Fig. 6).
3. Attach the front-assist handle and
the lower clamp on the shaft and
secure them by pre-tightening the
four screws. Turn the front-assist
handle upwards so that it points
toward the top of the handle (Fig. 7).
4. ST1500-S/ST1500-S-FC: Adjust the
front-assist handle position so that it
is between the rear handle housing
and the joint of the shaft, as shown
in Fig. 7. For ST1500/ST1500-FC
adjust the handle position so that it
is between the rear handle housing
and the warning label on the shaft.
Shorter users may adjust the handle
to a lower position (away from you) and taller users may adjust the handle to an
upper position (towards you). The handle should be adjusted so that your front
arm will be straight when using the trimmer.
5. Tighten the four screws so that the handle cannot be rotated on the shaft.
12
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
Always remove the battery pack from the product when you are
6
Lower Clamp
7
Front-Assist Handle