AL-KO solo Robolinho 4100 Traduction De La Notice D'utilisation Originale page 57

Start-up
■
The boundary cable is not routed properly
around corners (02/c).
■
The boundary cable is crossed over or not
routed clockwise (02/d).
■
The boundary cable is routed too imprecisely
so that edge areas of the grass surface can-
not be mowed (02/e).
■
The start points are set too far away from the
base station (02/f).
■
The boundary cable is not routed lying direct-
ly next to itself when guided towards and
back from the edge to an obstacle inside the
lawn (02/g).
■
The boundary cable is routed beyond the
edge of the grass surface (02/h).
■
When routing the boundary cable, the mini-
mum distance for corridors of 30 cm is under-
cut (02/i).
■
The boundary cable is routed too close (i.e.
at a distance of less than 15 cm) to obstacles
that cannot be driven over (02/j).
4.6 Connecting the base station to the
power source (05)
1. Place the transformer (05/1) at a dry location,
protected from rain and spray.
2. Unwind the low voltage cable (05/3) of the
base station (05/4) and route (protected from
damage) to the site of the transformer.
3. Connecting the low voltage cable to the
transformer:
■
Unscrew the screws of the luster terminal
(05/2) until a wire of the low voltage cable
can be inserted into each opening.
■
Insert the wires.
Note: Attention does not have to be paid
to the polarity.
■
Screw in the screws of the luster terminal
until the wires have been securely
clamped.
4. Plug the mains connection cable (05/5) of the
transformer into the power socket.
NOTE
We recommend connecting the trans-
former to the mains supply via an earth
leakage circuit breaker (ELCB) with a
rated leakage current < 30 mA.
457296_b
All manuals and user guides at all-guides.com
4.7 Checking the connections on the base
station (05)
1. Check that both LEDs (05/8, 05/9) light. If
not:
■
Disconnect the mains plug.
■
Check that all plug connectors of the
power source and the boundary cable
are positioned correctly and check for
damage.
2. If necessary, loosen the screws (05/7) on the
cover (05/6) of the base station and remove
the cover.
Status indications of the LEDs
LEDs Operating states
■
Green Lights up when the boundary
(05/9) cable is laid correctly and the
loop is intact.
■
Flashes if a loop of the bound-
ary cable is not in order.
■
Yellow Lights up if the power source is
(05/8) intact.
■
Flashes if the appliance is in the
base station and is being
charged.
5 START-UP
This chapter describes the activities and settings
that are necessary to put the automatic lawn
mower into operation for the first time. For all fur-
ther settings, refer to see chapter 7 "Settings",
page 59.
5.1 Charging the rechargeable battery (09)
The integrated battery is partially charged on de-
livery. During normal operation, the battery of the
appliance is regularly charged automatically.
NOTE
Fully charge the rechargeable battery
before using it for the first time. The re-
chargeable battery can be charged in
any charge status. Interrupting charging
does not damage the rechargeable bat-
tery.
The rechargeable battery can only be
charged after the appliance has been
switched on.
57