GE GFDR480 Manuel D'utilisation Et D'installation page 34

REVERSING THE DOOR SWING (if desired)
RE-LOCATE HINGE ASSEMBLY AND
5
HANDLE SPACER
A. Place the inner door frame on a soft and flat
surface so that the inner door gasket is facing
updwards.
B. Remove 6 screws (#8 x 1/2") that secure the
hinge assembly and handle spacer.
C. Separate the hinge assembly, door plug (on
some models), handle spacer or handle spacer/
latch assembly (depending on model) from the
inner door frame.
Door plug
(on some models)
Hinge
assembly
Installation Instructions
Handle spacer/
Latch assembly
(on some models)
or
Handle spacer
(on some models)
34
RE-LOCATE HINGE ASSEMBLY AND
5
HANDLE SPACER (cont.)
D. Rotate hinge assembly 180 degrees and
re-locate it and the door plug (on some models)
on the opposite side of the inner door frame.
E. Rotate the handle spacer or handle spacer/latch
assembly (depending on model) 180 degrees and
re-locate on the opposite side of the inner door
frame.
Handle spacer/
Latch assembly
(on some models)
or
Handle spacer
(on some models)
F. Re-install screws securing hinge assembly and
handle spacer.
Door plug
(on some models)
Hinge
assembly