Publicité
Les langues disponibles
Les langues disponibles
Fixed-point Cleaning
In which case to use this mode? The fixed point cleaning mode should be used
when there is dust or dirt concentrated in the same area. The robot vacuum cleaner
cleans the floor in a spiral path in the specified area and returns to the point of origin
after cleaning.
Setting method: Press this key on the remote control to enable fixed-point cleaning.
Cleaning Along the Edge
In which case to use this mode? The baseboard cleaning mode should be used to
clean the ends of a room. The robot cleans the floor along the walls and returns to its
charging base after cleaning.
Setting method: Press this key on the remote control to enable cleaning along the
edge.
Manual Control
You can control the robot by manual control and directional arrows on the
remote control.
Setting method: Press the key
on the remote control to
control the product in moving forward, moving backward, or making a turn.
Using the Product - Pause, Wake-up and Shut down
Pause: when the robot is running, press the ON / OFF button directly on the robot to
pause it. Or, press
on the remote control.
Sleep mode: If the robot is paused for more than 10 minutes, sleep mode is activated
and the robot indicator light goes out. To reactivate it, press the ON / OFF button
directly on the robot or the ON / OFF button on the remote control to restart it.
Stop: To stop the robot, hold down the ON / OFF button directly on the robot for a
few seconds. The light will go out.
* Once the robot has finished its operation, it is advisable not to turn it off completely.
Keep the robot in charge state so that it can perform better in the next operation. If
the robot is deactivated, it will not recharge.
EN-15
Publicité
