Sony VPL-SW525C Guide De Référence Rapide page 44

Installing Batteries
Remote Commander
1
Pull out the lithium battery
compartment.
Pull out the battery compartment with a
stick as shown in the illustration.
2
Insert a lithium battery.
3
Close the lithium battery
compartment.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
obey the law in the relative area or country.
Installing batteries
One lithium battery (CR2025) is supplied
for the RM-PJ7 Remote Commander. To
avoid risk of explosion, use a lithium battery
(CR2025).
10
GB
Checking the Supplied Accessories
Interactive Pen Device
1
The battery cover is attached to the
Interactive Pen Device by a small strap. Be
careful not to break the strap when opening
the battery cover.
2
3
Installing batteries
Four size AAA (R03) batteries are supplied
for the IFU-PN100M/IFU-PN100S
Interactive Pen Device. To avoid risk of
With the 3 (plus)
explosion, use size AAA (R03) manganese
side facing up.
or alkaline batteries.
Remove the battery cover.
Insert two size AAA batteries.
Re-attach the battery cover.