Assembling The Handle - Tekna Model (Dual Handle) - Duplex STANDARD 340 Instructions D'utilisation Et D'entretien

5.2.1

ASSEMBLING THE HANDLE - TEKNA MODEL (DUAL HANDLE)

1) Introduce the elbow 1 into the seat of the support 2
2) Tighten the two screws 3 using the screwdriver provided and tighten well
3) Install the second elbow 7 using the fixing screws 8 and 9.
4) Install the pre-assembled handle 4 using the joining insert 10 and the screws 11
5) Join the opposite side of the pre-assembled handle 4 using the connecting plate 5
and the cable-hook joint 16 using the three screws 6 facing inwards and tighten using
the same screwdriver.
6) Adjust the screw 12 of the tensioning regulator 13 located under the lever 14 of the
handgrip
7) paying attention to the movement of the feelers 15 that allow the liquid to flow from
the tanks.
8) Make sure that the feelers 15 remain flush with the side panel when the lever 14 is
not pulled.
Rev.
1.0
5
6
6
16
6
15
15
97
ASSEMBLING THE APPLIANCE
14
12
4
13
11
10
5
11
1
7
2
3
3
DUPLEX 340/420/620
7
8
9
F.8