Extremis INUMBRINA Instructions De Montage page 17

MONTAGE INUMBRINA AUF BODENPLATTE
WAS SIE BRAUCHEN
1 Person
inbusschlüssel Nr. 4
+/- 20 min.
Heavy duty Sonnenschirmständer
1. Place one of the two galvanised
base plates on the ground.
position the second base plate on
top of it, make sure the square
holes match the round holes with
thread of the rst base plate. Now
place the stainless steel tube on
top of the two base plates and
make sure the holes of the tube
match with the square holes of the
second base plate. Mount the
stainless steel tube on it with 3
bolts M6x20. Attention: Make
sure that you x the bolts in the
thread of the rst base plate as
shown on the drawing!
2. Plaats vervolgens de Inumbrina
parasol in de basis, en vergrendel
door de stelschroef in wijzerzin te
draaien. Pas als de Inumbrina niet
meer rond haar as kan bewegen, is
de stelschroef voldoende
vastgeklemd.
Standard Sonnenschirmständer
1. Place the galvanised steel base
plate on the ground and mount the
stainless steel tube on it with 3
bolts M6x12. Attention: Make sure
that you x the bolts in the thread
of the base plate as shown on the
drawing.
en
2. Insert the Inumbrina parasol
in the anchor tube and fasten it
by turning the adjusting screw
clockwise. Always
the adjusting screw until the
InUmbrina can no longer revolve
on its axle.
deutsch
tighten
17