Sharp KH-6I19FT0 -EU Guide D'utilisation page 37

7- Key lock indicator
8- Smart pause
9- Decrease heat setting/timer
10- Timer selection
11- Boost
12- On/Off
Use the induction cooking zones with
suitable cookware.
After mains voltage is applied, all displays
are illuminated briefly. After this, the hob is
in stand-by mode and ready for operation.
The hob is controlled by pressing the
appropriate electronic button. Each button
pressed is followed by a buzzer sound.
Switching the appliance On
Switch the hob on by pressing the ON/OFF
button . All heater displays will show a
static "0" and the bottom right dots blink.
(If a cooking-zone is not selected within 20
seconds, the hob will automatically switch
off).
Switching the appliance Off
Switch the hob off at any time by pressing
.
The ON/OFF button
over the switch-off function.
Switching the cooking-zones On
Press the heater selection button that
corresponds to the heater you wish to use.
A static dot will be shown on the selected
heater display and the blinking dots on
all other heater displays will no longer
illuminate.
Select the temperature setting by using the
increase heat setting button
heat setting button
now be ready to use. For faster boil times,
select the desired cooking level and then
press the "P" button to activate the Boost
function.
Switching the cooking-zones Off
Select the element you want to switch off by
pressing the heater selection button. Using
the button, turn the temperature down
to "0". (Pressing the
simultaneously also turns the temperature
always has priority
or decrease
. The element will
and buttons
to "0").
If the cooking zone is hot, "H" will be
displayed instead of "0".
Switching all cooking-zones Off
To switch all the cooking zones off at once,
press the
In the stand-by mode, a "H" will appear on
all cooking zones which are hot.
Residual Heat Indicator
The residual heat indicator indicates that
the glass ceramic area has a temperature
that is dangerous to touch.
After switching off the cooking zone, the
respective display will show "H" until the
corresponding cooking zone temperature is
at a safe level.
Smart Pause
Smart Pause, when activated, reduces
the power of all burners that have been
switched on.
If you then deactivate the Smart Pause,
the heaters will automatically return to the
previous temperature level.
If the Smart Pause is not de-activated, the
cooktop will switch off after 30 minutes.
Press to activate Smart Pause. The
power for the activated heater(s) will reduce
to level 1 and "II" will appear at all displays.
Press again to deactivate Smart
Pause. "II" will disappear and the heaters
will now run at the level previously set.
Safety Switch-Off Function
A cooking zone will automatically switch off
if the heat setting has not been modified
for a specified duration of time. A change
in the heat setting of the cooking zone will
reset the time duration to the initial value.
This initial value depends on the selected
temperature level, as shown below.
Heat setting
1-2
3-4
5
6-9
EN - 15
button.
Safety switch off after
6 Hours
5 Hours
4 Hours
1.5 Hours