Publicité
Les langues disponibles
Les langues disponibles
English
ADJUSTING BELT TRACKING (Fig. F)
CAUTION
Keep hands away from idler drum while adjusting belt
tracking.
1. Make sure tension lever (2) is tight (toward drive drum).
2. Quickly turn the switch ON and OFF to check the
tracking. Belt (1) should ride centered on idler and drive
drums. Adjust tracking nut (3) as needed to center belt
on drums.
3. If belt moves to the left, turn tracking nut to the right.
If belt moves to the right, turn tracking nut to the left.
4. Quickly turn switch ON and OFF again. If belt moves to
one side, continue adjusting tracking nut as needed
to center belt on drums.
Fig. F
ADJUSTING BELT ASSEMBLY POSITION (Fig. G)
Sanding belt assembly (1) can be adjusted from vertical
to horizontal position, or any angle in between.
1. Loosen socket head bolt that is threaded into pivot
bracket.
2. Tilt belt assembly to desired position. Secure belt
assembly position by tightening socket head bolt in
pivot bracket.
3. Adjustable positive stops are provided for both horizontal
and vertical positions.
NOTE: The horizontal limit stop is located on top of the base.
Fig. G
1
2
All manuals and user guides at all-guides.com
1
3
2
– 12 –
ADJUSTING TABLE ANGLE (Fig. H)
Table tilts from 0 o 45
and will be within +/-3
°
1. To adjust table angle, loosen handle (1), tilt table (2) to
desired angle on scale (3) then secure by tightening
handle.
2. Make sure the gap between table and belt is 1/16" or
less. If necessary, loosen bolt (4) and reposition table.
Secure with bolt.
Fig. H
HORIZONTAL BELT SANDING WITH WORK STOP (Fig. I)
1. Remove table from belt assembly (1).
2. Tilt belt assembly from vertical to horizontal position
and secure in position.
3. Work stop (2) has been integrated into dust shroud (3).
4. Idler drum can be used as a contact drum to sand
surfaces.
Fig. I
.
°
3
2
1
4
3
2
1
Publicité
