Mitsubishi Electric TRANE TPKA0A 1KA Serie Manuel D'utilisation page 8

3. Operation
3.3. Temperature setting
<Cool, Drying, Heat, and Auto>
Fri
Operation mode
83
Room
Room temperature (Refer to the Installation Manual.)
Cool Set temp. Auto
83
Mode Temp. Fan
F1 F2 F3 F4
ON
RETURN SELECT
MENU
OFF
HOLD
Press the [F2] button to decrease the preset temperature, and press the
[F3] button to increase.
• Refer to the table on 3.1 for the settable temperature range for diff erent
operation modes.
• Preset temperature range cannot be set for Fan/Ventilation operation.
• Preset temperature will be displayed either in Centigrade in 0.5- or
1-degree increments, or in Fahrenheit, depending on the indoor unit
model and the display mode setting on the remote controller.
3.4. Fan speed setting
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
F1 F2 F3 F4
ON
RETURN SELECT
MENU
OFF
HOLD
Press the [F4] button to go through the fan speeds in the following order.
• The available fan speeds depend on the models of connected indoor
units.
Notes:
The number of available fan speeds depends on the type of unit
●
connected.
In the following cases, the actual fan speed generated by the unit
●
will diff er from the speed shown the remote controller display.
1. While the display is in "Standby" or "Defrost" states.
2. When the temperature of the heat exchanger is low in the heat-
ing mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the tem-
perature setting.
4. In COOL mode, when room temperature is lower than the tem-
perature setting.
5. When the unit is in Drying mode.
7
3.5. Airflow direction setting
3.5.1 Navigating through the Main menu
<Accessing the Main menu>
Main Main menu
Operation
F1 F2
RETURN SELECT
MENU
<Item selection>
Main Main menu
Initial setting
F1 F2
RETURN SELECT
MENU
<Exiting the Main menu screen>
83
Room
Cool Set temp.
83
Mode Temp.
Auto F1 F2
RETURN SELECT
MENU
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will
be lost.
<Display of unsupported functions>
Title
Not available
Unsupported function
Return: RETURN
F1 F2
RETURN SELECT
MENU
Press the [MENU] button on the
Main display.
The Main menu will appear.
F3 F4
ON
OFF
HOLD
Press [F2] to move the cursor left.
Press [F3] to move the cursor right.
Cursor
F3 F4
ON
OFF
HOLD
Press the [RETURN] button to exit
Fri
the Main menu and return to the
Main display.
Auto
Fan
F3 F4
ON
OFF
HOLD
The message at left will appear
if the user selects a function not
supported by the corresponding
indoor unit model.
F3 F4
ON
OFF
HOLD