ergoCentric upCentric UP-2LV Guide De L'utilisateur page 4

Standard features
Presettable memory positions
upCentric electric height adjustable tables come standard with 4 presettable
®
memory positions, allowing you to set customized seated and standing table
heights, and to quickly adjust to these positions when changing between seated
to standing positions. See page 12 for instructions on setting memory positions.
One-touch adjustment
Once you have set a memory position, you no longer have to hold the up
or down button to adjust the table. Simply press the ❶, ❷, ❸ or ❹
button for your desired memory position and the table will automatically
adjust to your preset position.
Minimum / maximum heights
You can set a minimum or maximum allowable adjustment height at any
position within the adjustable range of the table. If you have something
above or below your work surface ( such as a storage pedestal under your
desk or a shelf mounted to above your work surface ), these limits can be
set to avoid accidental contact, eliminating instances of damage or injury.
These adjustment settings can be cleared and re-set at different positions
at any time. See pages 12 and 13 for instructions on setting min/max height limits.
Customizable digital display settings
There are two changeable options for the digital height readout on the
digital display handset:
1. Changing desk starting height
The default starting height on the digital height readout is 22.9",
which is the accurate minimum table height for this table when using
a 1" thick work surface and standard glides; however, if you add casters
or retrofit the table frame onto a tabletop that is thicker or thinner than
1" the starting height may be higher or lower than 22.9". In these cases,
the digital height readout can be adjusted so that the starting height is
accurate to the actual lowest height of the work surface. See page 13
for instructions.
2. Converting between metric and imperial measurements
The default unit of measure ( UOM ) displayed on the digital height
readout is inches; however, you can change between inches and
centimetres for your desired UOM. See page 14 for instructions.
upCentric – UP-2LV Owner's Manual | Guide de l'utilisateur
®
3