ergoCentric upCentric UP-2LV Guide De L'utilisateur page 13

Getting started
The first time a table is assembled, the legs must be synchronized before use.
OOO
1 2
How to synchronize
Press and hold the up/down buttons on the handset at the same time
for 3-5 seconds, both legs will begin to lower. Continue holding the buttons
until both legs reach the lowest position.
When finished synchronizing, the legs will stop moving and the handset will
make a beep sound and the buttons can be released. The display will show
the starting height.
How to set a memory position
Use the and
Hold the button and the desired memory button ( ❶, ❷, ❸ or ❹ )
together until it beeps and P1, P2, P3 or P4 is shown on the display screen.
Now you can press the memory button and the table will automatically
move to the preset memory position.
P2
1 2
How to set a maximum height limit
Move the table to the desired maximum height.
Press and hold the
the button 4 times.
A beeping sound will notify you that the process has completed.
Note: You must press the
press and you must continue to hold the
setting will not work.
12 upCentric – UP-2LV Owner's Manual | Guide de l'utilisateur
®
3 4
buttons to adjust table to the desired height.
3 4
button while simultaneously pressing
and button at the same time on the first
button the entire time, or this