Publicité
Les langues disponibles
Les langues disponibles
Synchronize table legs
Prior to performing any troubleshooting, perform a re-synchronization.
On occasion, the table may require a re-sync for a variety of reasons.
This is normal.
•
Ensure there are no obstructions for the desk to move vertically.
•
Press and hold
•
Continue to hold
until it reaches the bottom ( lowest point ).
•
Release the buttons once the system beeps.
•
If it does not beep, or if the desk is not level,
repeat the re-sync operation.
•
This operation may be required a few times
until the desk is at the lowest level position.
The system has now been re-synchronized.
E00
E01
E02
E03
E04
E11
E12
E13
E21
E22
E23
E31
E32
E33
and
at the same time.
and
while the desk lowers
Error codes
Synchronization in progress
Overuse protection
Unbalance protection
Anti-collision
T-touch protection
M1 motor over-current protection
M2 motor over-current protection
M3 motor over-current protection
No Hall sensor from M1
No Hall sensor from M2
No Hall sensor from M3
No current from M1
No current from M2
No current from M3
upCentric
– UP-2LV Owner's Manual | Guide de l'utilisateur
®
15
Publicité
