ergoCentric upCentric UP-2LV Guide De L'utilisateur page 10

Step 4 – Adjust frame width :
4.1 :
Unclip wires from wire clips ( shown with circles )
and loosen 8 bolts on inside of frame ( shown with arrows ).
4.2 :
Adjust frame by sliding each side in opposite directions until
holes in tabletop brackets ( I ) are aligned with pilot holes on tabletop.
4.3 :
Retighten 8 bolts on inside of frame, then reclip wires back
into wire clips.
Note :
Pilot holes make installation quick and easy, but they are
not always necessary. If your tabletop does not have pilot holes,
the ideal frame width is 2"- 4" shorter than the tabletop width
( leaving 1"- 2" of overhang on each side ).
i.e. on a 60" wide tabletop, ideal frame width is 56"-58".
4.1
upCentric – UP-2LV Owner's Manual | Guide de l'utilisateur
®
4.2
4.3
9